|
|
| Разместил: |
al7  |
| Источник информации |
mods.dk |
| Необходимые детали, приборы, инструменты |
Отвертка, паяльник |
|
Текст статьи: •
|
Делал не я лично, поэтому привожу статью в оригинале:
Remove the 100 ohm resistance indicated in the following picture
Remove this resistance
Connect the central wire of the coaxial cable in the point indicated in the picture (where the 100 ohm resistance was connected):
SOLDER THE CENTRAL WIRE OF THE COAXIAL CABLE IN THIS POINT (see below picture)
Add a 5.6 pF condenser paralleling to C182 (see picture)
Add a 4.7 condenser paralleling to C179 (see picture)
Add a 68 Pf condenser paralleling to C163 (see picture)
Operate on the VR13 trimmer to increase the power in AM (turn clockwise to increase). In order to reach the optimum modulation, we suggest adjusting this trimmer to a 8/9 Watt power;
Operate on VR14 trimmer to increase the level of modulation in AM (turn clockwise to increase);
Operate on VR12 trimmer to increase power in SSB (turn clockwise to increase);
Select the unit in FM on 20 Channel (27.205 MHz) and adjust the following coils: L40, L42, L43, L44, L18 to obtain max. output power;
Make sure that the power supplied from the unit in SSB is regular in all the bands; if not, operate on the above mentioned coils to verify the level of the supplied power on the different working bands.
У меня получилось 25 Вт AM, FM и 40 Вт USB.
Огромная благодарность Top Secret, за подсказку и U32 за реализацию.
Фото mods.dk
|
|
•
|
|
Добавлять комментарии могут только зарегистрированные, активировавшие регистрацию и не ограниченные в доступе участники сайта!
|
| Файл создан: 13 Мар 2008 16:58:42, посл. исправление: 14 Мар 2008 22:51:59 |
|
